173294-12968710.jpg

SHAMA SPRINGS

Extension Spring Details

We Manufacture Extension Springs Ranging from WD 0.3mm to 60 mm

 

Measurements

  1. Hold the spring in one hand, and the calipers on the other hand.

  2. Place the calipers across the outside coil, either at the end of the center of the spring. This is called the Outside Diameter (O.D.).

  3. Place the calipers on the wire at one end of the body coil of the spring. This is called the Wire or Material Size.

  4. Place the calipers (or tape measure) on the full length of the spring, inside the hooks. This is called the Length (L.I.H.). (see diagram for example)

 

Materials

The highest grades of spring wire are used in manufacturing Shama Spring products. Certifications of conformance for geometric tolerances for our stock springs are available upon request. We only offer material certifications for custom springs.

“Spring steel” is a term that includes music wire, hard-drawn wire, and oil-tempered wire. Alloy steels for stock extension springs are offered only in 300 series stainless.

Tolerances

Tolerances for extension spring rates depend upon the body-diameter to wire-diameter but are usually +/- 10% and +/- 5% on the diameter. The initial tension is much more difficult to control and is offered as a reference value only.

Ends

The ends on the extension springs offered in our stock inventory are the common machine-made hook and full-loop configurations. The hooks or loops may have an across center transition of the last coil before forming the hook or loop. The angle between hook/loop planes (end position) is random. If you need a specific end configuration, it is best to contact our custom spring department.

 

Finishes

Our stock extension springs contain a selection of commonly requested finishes:

  • Zinc (upon request)

  • Gold Irridite (upon request)

  • Black Oxide (upon request)

  • Passivated (upon request)

  • None (upon request)

  • None (can be plated upon request)

173294-12968704.jpg

SHAMA SPRINGS